Multiblades
Woodworking Vise for
the MFT3
Can be installed and removed in
seconds and placed anywhere
around the MFT3.  It comes with
all the necessary hardware to
make  a deadman.
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
The vise hangs from the extrusion anywhere around the table and it is secured in place  with the
special hardware provided. Simply, slide the hardware into the slot on each end of the vise bracket
and tighten using a 1/2" wrench. The vise comes fully assembled with vise pads and a metal dog.
Ready to install and use.
_______________________________________________________________________________________________________
Hardware to build a deadman is provided along with the vise. We recommend making it
from a 2x4 as shown on the pictures.
The deadman should be 1"- 3/16" thick so it is flush with the pad on the stationary jaw of
the vise.
The recommended length is 35", so the top of the deadman is flush with the top of the
MFT3.
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
Watch video on using the vise and working with the Domino. Click Here
Watch video on using the vise for sanding, sawing, planning, etc. Long video, Click Here
_______________________________________________________________________________________________________
                  Specifications

Vise width: 6-1/2"
Jaws opening with pads: 3"
Jaws opening with front pad removed: 3-3/4"
Jaws opening without pads" 4-1/2"
Metal dog: Steel, 3" x 3/16" x 3/4"

Pads are easily removed.
Woodworking vise for the MFT3.
Includes hardware to build a deadman.

$
58
Watch video on installing and removing the vise. Click Here